Community
cancel
Showing results for 
Search instead for 
Did you mean: 
DDUNN
Beginner
270 Views

Part#EK-10M08E144 power connection

When the customer connect USB cable to EK-10M08E144, red LEDs turned on continuously. Per datasheet, When powered correctly, a pre-programmed design blinks LEDs D1 through D5 ON half a second then OFF half a second. Is this product out of order? or how should the customer proceed? please help to advise. Thank you. Dan.lee@mouser.com

EK-10M08E144.PNG

0 Kudos
1 Reply
AnandRaj_S_Intel
Employee
80 Views

Hi Dunn,

 

Board is pre-programmed with different design.

 

MAX 10 FPGA (10M0S, 144-EQFP) Evaluaion Kit User Guide is not been updated,The pre-programmed design is connection between SW3 (1 - 5) and led (D1 - D5).

You can change SW3 state to see the difference.

Sorry for the inconveniences caused.

 

Regards

Anand

 

 

Reply