FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5930 Discussions

Permanent design

Altera_Forum
Honored Contributor II
‎05-07-2010 12:30 PM
1,170 Views

Hello 

I have the Stratix2GX EP2SGX90E dvelopment kit, and until now I used the sof file to load the design into the board. The problem with this method is that when the boards powers down the design is erased. Is it possible to load the file in to the board somehow that it wont be erased when it powers down?
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-10-2010 09:16 AM
244 Views

If you have the licences for all the IP modules that you use, you can store the design in a configuration memory on the board. The board documentation should give you the procedure.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.