- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all, I have a little question about the pinout of this board. I 'have this board --> http://www.altera.com/literature/manual/mnl_nios2_board_stratixii_2s60.pdf and I want to put in operation the CompactFlash connector. So I saw the pinout/signals in the document (http://www.altera.com/literature/hb/nios2/qts_qii55005.pdf ) and then I compared it with the full_featured pinout. I saw that the signal we_n was linked to C11 pin, but in full featured it was linked to E10. Can someone explain about this ? Thanks in advice.
P.S. Sorry for my bad english.Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't know the specific board, but ALTERA pin out files might have mistakes, if there is a conflict use the information from the schematics.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, thanks ^_^
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page