- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I got a new version DK-DEV-3C120N, but I found SDRAM and SRAM have been replaced with new component.
And I can’t get some more detail information about that, andall sample code about RAM can’t be run. Can you give me some advice and help me? The following is text above these chips: DDRRAM X 4: 3IH22 D9LHT 6RDR DDRRAM X 1: 3RG22 D9LQG DTFD SRAM: 3SB47 PW755 GC9BLink Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately the latest installation kit is only up to Quartus version 11.1
ftp://ftp.altera.com/outgoing/devkit/11.1/cycloneiii_3c120_dev_kit-v11.1.0.exe does this work?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It does not work!
I have tried every sample code with every version. I am sure, the SRAM and SDRAM have been changed..... If you burn factory binary file to the board(new version with new sram and new ddr), the item about memory test will fail when you run "BoardTestSystem.exe". And the older version DK 3C120 is Ok!!!- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately I can't help much here. You can try contacting Altera support to see if there is any updated installer, but I really doubt so... :(
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page