FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5931 Discussions

Problem with FPP programming with part Cyclone V - 5CGXFC3B6U15A7N

YMalk1
Beginner
‎07-15-2019 10:06 AM
546 Views

Hi,

i have design board with the cyclone V part - 5CGXFC3B6U15A7N - and i wish to program is with STM - MCU that connected in FPP mode with flash. i have done the program in the MCU and check the Data line and its seems to be O.K. but the CONF_DONE I/O is not getting up, the speed of the data transfer from the flash to the FPGA is very low as 100khz, that data line have a pull-up resistors and the DCLK signal have a pull-down resistor, can you advice what is the problem ?

0 Kudos

Link Copied

1 Reply
YuanLi_S_Intel
Employee
‎07-18-2019 07:24 AM
304 Views

Hi Yoram,

 

You mentioned that pull down on DCLK and Data. As per user guide at link below, seems like it cannot be. You will need to follow the connection as shown at user guide below:

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-v/cv_5v2.pdf (Page 255)

 

Regards,

YL

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.