FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5931 Discussions

Programming Flash on Altera Cyclone III Starter Board

Altera_Forum
Honored Contributor II
‎07-31-2008 08:51 PM
1,099 Views

Hi, 

 

Does anyone know if I need a JTAG cable or I can use the USB Blaster on Quartus to program the FLASH on the board? Download my own program once it powers up instead of the LED counters that it has already loaded. I read the user guide and its should be fine with the USB blaster but just not quite sure. 

thanks, 

JC
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎07-31-2008 09:40 PM
376 Views

Yes, the configuration can be updated by the on-board USB Blaster. User guide Appendix A. programming the configuration flash device gives a detailed description of the procedure.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.