Programming a cyclone 4e device

[mehta_expai]

Hello,

I have one FPGA driver board consisting CYCLONE 4E device. Whenever i am trying to program the device using JTAG blaster, quartus web edition software detect usb blaster but cyclone 4 e device not detected by quartus software.Sharing some screensnap,please take a look.

Thanks

[ak6dn]

It would appear that the JTAG chain on your board is broken. Is it just the one Cyclone device in the chain?

I would use the JTAG debugger feature to check signal continuity.

[Farabi]

Hello, 

Quartus Web Edition is no longer supported , you may want to install Quartus Prime Lite Edition (Free) to get technical support. 

link : https://www.intel.com/content/dam/support/us/en/programmable/support-resources/bulk-container/pdfs/literature/po/ss-quartus-comparison.pdf

regards,
Farabi