FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
5853 Discussions

Repair of Arria 10 GX FPGA Development Kit

RyanT
New Contributor I
441 Views

Hi,

I bought an Arria 10 GX FPGA Development Kit from Mouser in February 2021. Initially it worked well. In September 2021, it started to show some instability in JTAG interface via the on-board USB blaster interface and sometimes the JTAG interface is not detected. The JTAG detection failure rate increases as time goes by. By end of 2021, the on-board JTAG interface cannot be detected.

I bought an external USB Blaster II cable and it can program SOF file to the Arria 10 FPGA. Arria 10 can operate and function accordingly to SOF coding.

Hence, it seems to be a localized issue on the JTAG interface (Cypress USB transceiver / MAX 2).

Can you advise if the board can be repaired?

0 Kudos
5 Replies
AR_A_Intel
Employee
433 Views

Hello

 

Welcome to INTEL forum. May we know, is this the board that you’re referring to? https://www.intel.com/content/www/us/en/products/details/fpga/development-kits/arria/10-gx-signal-integrity.html


0 Kudos
RyanT
New Contributor I
426 Views
0 Kudos
AR_A_Intel
Employee
419 Views

Hi

 

Thanks for update. Could you provide the following for warranty checking?

 

Name:

Email Address:

Company/University Name:

Dev kit OPN :

Serial Number :

 

You can reply/attach your file in private message.


0 Kudos
RyanT
New Contributor I
414 Views

Sure, I've provided the information in private message.

0 Kudos
AR_A_Intel
Employee
390 Views

Solution is provided in private message mail. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you


0 Kudos
Reply