Resetting the board

[Altera_Forum]

Hai, 

  I am using Altera Cyclone V board https://www.altera.com/products/boards_and_kits/dev-kits/altera/kit-cyclone-v-soc.html  I used the preloader generated by bsp-editor, programmed the same using HPS software to QSPI flash memory.  Next to preloader I programmed the baremetal-application(LED blinking program). I programmed the same using HPS software to QSPI flash memory.  After power-on reset, the execution of program is perfect, First the preloader executes and then my program executes..  But When I press, the reset buttons in the board, there is no response.   1. When i press warm and cold reset button, the controller is hanged.  2. When I press cpu reset button, there is no response.   Could any one please help me to solve the issue..

[Altera_Forum]

look, i caught by this issue before, it was some bug with the board reset mechanism that causing the system failed to boot in qspi mode!

[Altera_Forum]

--- Quote Start ---  look, i caught by this issue before, it was some bug with the board reset mechanism that causing the system failed to boot in qspi mode!  --- Quote End ---    And how did you solve it? Or what did you do a out it? x

[Altera_Forum]

fastest way is use QSPI Flash Part which is < 16MB capacity.