FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits

Resetting the board

Altera_Forum
Honored Contributor II
1,141 Views

Hai, 

 

I am using Altera Cyclone V board https://www.altera.com/products/boards_and_kits/dev-kits/altera/kit-cyclone-v-soc.html 

 

I used the preloader generated by bsp-editor, programmed the same using HPS software to QSPI flash memory. 

 

Next to preloader I programmed the baremetal-application(LED blinking program). I programmed the same using HPS software to QSPI flash memory. 

 

After power-on reset, the execution of program is perfect, First the preloader executes and then my program executes.. 

 

But When I press, the reset buttons in the board, there is no response.  

1. When i press warm and cold reset button, the controller is hanged. 

2. When I press cpu reset button, there is no response. 

 

 

Could any one please help me to solve the issue..
0 Kudos
3 Replies
Altera_Forum
Honored Contributor II
415 Views

look, i caught by this issue before, it was some bug with the board reset mechanism that causing the system failed to boot in qspi mode!

0 Kudos
Altera_Forum
Honored Contributor II
415 Views

 

--- Quote Start ---  

look, i caught by this issue before, it was some bug with the board reset mechanism that causing the system failed to boot in qspi mode! 

--- Quote End ---  

 

 

And how did you solve it? Or what did you do a out it? 

x
0 Kudos
Altera_Forum
Honored Contributor II
415 Views

fastest way is use QSPI Flash Part which is < 16MB capacity.

0 Kudos
Reply