FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6125 Discussions

Run / Debug problems with NIOS on Cyclone V SoC Dev Board

Altera_Forum
Honored Contributor II
1,224 Views

Hi all, 

 

i want to build a system with a Nios Core and the software will run on the hps ram. My first step i built the system with nios core and with fpga ram. I test my software with "Nios for eclipse" with the Tool "Run as -> NIOS II Hardware". Which rans. 

My next step i changed the fpga ram to hps ram but if i want to debug or to run the software in "NIOS for eclipse" i get the error: 

 

Using cable "USB-BlasterII [USB-1]", device 1, instance 0x00 

Pausing target processor: not responding. 

Resetting and trying again: FAILED 

Leaving target processor paused 

 

I use Quartus 14.1 

My QSYS Build 

http://www.alteraforum.com/forum/attachment.php?attachmentid=11147&stc=1  

 

I think i have problems with the Ram Timings but i didnt find any descriptions about the settings for this dev board Cyclone V SoC.
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
521 Views

I wouldn't recommend doing this. Memory contention will slow down the HPS significantly. It's much better to use on-chip ram or a separate ram chip for the NIOS. The added cost for extra ram chip(s) isn't much considering the cost of the SoC itself.

0 Kudos
Reply