- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I have posted already my question in the section university program but did not get any answers: SD-Card IP Core changes for DE0-Nano board support Hello, I am in a situation to port my application from the DE1-board to the DE0-Nano board( 32 MB SD-Ram!) The remaining problem is, to get the Altera University Program, Secure Data Card IP Core ported to DE0-Nano. I used the circuit diagram from the DE1-board ( see attached post ) and connected a SD-Card interface to the GPIO connector as follows: DE1-Board my_DEO-Nano b_SD_cmd: PIN_Y20 PIN_B11 b_SD_dat: PIN_W20 PIN_D11 b_SD_dat3: PIN_U20 PIN_C11 o_SD_clock: PIN_V20 PIN_A12 The Pins assignment of course is different which reflects in Errors if I want to add the IP Core to the SOPC. Has anyone an idea, which files I have to modify to bring the SD Card up and running on the DE0-Nano board ? I prefere the University Program, because it has FAT16 support, otherwise I have to use the SPI ? Regards, ReinhardLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page