FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits

SRAM capacity in UP3?

Altera_Forum
Honored Contributor II
1,229 Views

Hi, 

 

The book "Rapid Prototyping of Digital Systems" mentions that UP3 board supports 128KB of SRAM memory. But in my SOPC builder when I set the SRAM size to 512 KB, the SOPC builder is able to generate the system and Quartus II is also able to compile the design. 

 

But how is this possbile?Why does the book mention it as 128 KB and still I am able to successfully generate 512KB SRAM system? 

 

Thanks for the replies, 

Amjad
0 Kudos
3 Replies
Altera_Forum
Honored Contributor II
479 Views

the SRAM chip in my board is is61lv6416l and the data sheet http://www.issi.com/pdf/61lv6416_l.pdf also mentions 128 KB. Why is that I am not getting error when I compile with 512 KB SRAM?

0 Kudos
Altera_Forum
Honored Contributor II
479 Views

SOPC build and Quartus don't know about the chips outside the FPGA. 

They'll just trust whatever you say.
0 Kudos
Altera_Forum
Honored Contributor II
479 Views

@rbugalho, i dint know that. thanks for the info...

0 Kudos
Reply