- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good morning !!
I am are currently working on a project and we will wish to have more information concerning the schematic of the card of development stratix II EP2S60. We would like to know why you use a transformer ADT1-1WT 75Ohm while impedance of SMA is 50Ohm (figure 1)? Because it is necessary that one thus sends a signal in a coaxial cable 50 Ohm (figure 1) without loss of impedance are what one would not have had to put a transformer 50 Ohm. And also, why do you use two transformers of different impedance. One is 50 Ohm, (ADT2-1T) other is 75ohm (ADT1-1WT) .(figure 2) Best regards.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
UP !!
Is someone of support ALTERA tell me the function of this component ? Thanks !
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page