Schematics for DK-SI-AGI027FB

[Ben14]

I am looking to build a daughter card for the FMC+ connectors on this Intel FPGA board. Can I get the schematics for the board to make sure I have the proper signals on the FMC+ before we buy the card.  I basically want to put two Gen4x8 PCIe ports on each of  the FMC+ connectors for a total of four PCIe ports.

thank you

[Wincent_Altera · Accepted solution]

Hi Sam,

Nice to meet you again, you can get the schematic here ES Edition and ES2 Edition

For the Pin-out file you can get it at https://www.intel.com/content/www/us/en/support/programmable/support-resources/devices/lit-dp.html

Detail about Agilex Soc, user guide, Design example. golden_top design you can get it at

https://www.intel.com/content/www/us/en/products/details/fpga/development-kits/agilex/i-series-transceiver/si-agi027.html

let me know if you have any other further question.

Regards,

Wincent_Intel

[Ben14]

Thank you

[Wincent_Altera]

Hi,

Thanks for confirming the answer

Hence, This thread will be transitioned to community support.

If you have a new question, feel free to open a new thread to get support from Intel experts.

Otherwise, the community users will continue to help you on this thread. Thank you

If you feel your support experience was less than a 9 or 10,

please allow me to correct it before closing or let me know the cause so that I may improve your future support experience.

Regards,

Wincent_Intel

[Wincent_Altera]

Hi,

I wish to follow up with you about this case.

Do you have any further questions on this matter ?

​​​​​​​Else I would like to have your permission to close this forum ticket

Regards,

Wincent_Intel