FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6264 Discussions

Stratix 10 HPS - CoreSight Embedded Trace Macrocell Base Address

elrhod
Beginner
658 Views

Hi all,

I have been looking for the base address of the Stratix 10 HPS ETM for a couple of days already and cannot find it.

As you can see bellow, at the Stratix 10 HPS TRM we can find the CoreSight Component Address Table that presents the ETF, CTI, TPIU, Trace Funnel, STM, ETR among others but there is no information about the ETM (Embedded Trace Macrocell).

CoreSightAddresTable.PNG

Does anybody knows where can I find this information?

Thank you!

Eduardo.

Labels (1)
0 Kudos
1 Solution
JingyangTeh
Employee
613 Views

Hi Eduardo


The Embedded Trace Macrocell Address Registers are not listed for users to read/write.

From the information I got is that they are strictly for tool usage.

The debugger tool will access to those registers through their internal ROM table and read/write accordingly.

We do not need to read/write to the registers.


Regards

Jingyang, Teh


View solution in original post

0 Kudos
3 Replies
JingyangTeh
Employee
614 Views

Hi Eduardo


The Embedded Trace Macrocell Address Registers are not listed for users to read/write.

From the information I got is that they are strictly for tool usage.

The debugger tool will access to those registers through their internal ROM table and read/write accordingly.

We do not need to read/write to the registers.


Regards

Jingyang, Teh


0 Kudos
Kenny_Tan
Moderator
581 Views

Hi Eduardo,

 

Do you have further questions? If no, we shall close the case. 

 

Thanks,

KEnny

0 Kudos
JingyangTeh
Employee
543 Views

Hi


Since a solution have been provided and no feedback was received, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.


If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 10 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.



Regards

Jingyang, Teh



0 Kudos
Reply