FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6031 Discussions

Stratix 10: move data through the HPS SDRAM controller using the F2H AXI bridge.

ap_mercy
Beginner
513 Views

Hello, I'm trying to master data from the FPGA to SDRAM.  Which base address should I write to?

 

If there are examples out there I can use please link them. I can't find any.

0 Kudos
4 Replies
EricMunYew_C_Intel
Moderator
496 Views

You can find the base address of the FPGA-to-SDRAM bridge in your Platform Designer.


0 Kudos
ap_mercy
Beginner
483 Views

@EricMunYew_C_Intel wrote:

You can find the base address of the FPGA-to-SDRAM bridge in your Platform Designer.



@EricMunYew_C_Intel How can i confirm the bridge for FPGA-to_sdram bridge is enabled in the HPS?

0 Kudos
EricMunYew_C_Intel
Moderator
455 Views

The F2SDRAM bridge can be enabled in your Platform Designer, you may refer to the attached.

0 Kudos
EricMunYew_C_Intel
Moderator
439 Views

I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.



0 Kudos
Reply