- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have noticed that there's an error in the Stratix II EP2S180 DSP Development Board Reference Manual. In figures 2-11 and 2-13, the signal named PROTO1_CLKOUT and PROTO2_CLKOUT are assigned to Stratix II pins AC14 and B14, respectively. But I think that they are not! These assignments are from the Stratix II EP2S60 Nios II Development Board. (I guess this is a CTRL+C - CTRL+V issue) The correct Stratix II pins are T32 (for PROTO1_CLKOUT) and T30 (for PROTO2_CLKOUT) as it's specified in another section of the same document (Table 2-4, part 2, last row) Just wanted to share the information, cause I haven't found an Errata Sheet regarding this issue. Best Regards, GabrielLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page