System-Console. How to export a standalone executable/folder?

[covfefe]

Hello,

How can I provide a standalone version of the system-console? 

Quartus is really large (40GB), System-Console is all I need on the deployed target, and has the potential to only require ~10-100MB. 

Is there a way to download it, or export it? Thank you

[sstrell]

System Console is included in the separate Programmer download and installation (along with Signal Tap as well).

[covfefe]

Would you be able to share a download link? I can't seem to be able to find it

[sstrell · Accepted solution]

From the Download Center (https://www.intel.com/content/www/us/en/products/details/fpga/development-tools/quartus-prime/resource.html

 

[covfefe]

Thank you @sstrell. I had been looking for a few days, and never found this. 

[sstrell]

Yeah, the web site is tricky sometimes.  To get there: Products (at top of page) -> Intel Quartus Prime Design Software -> Downloads.

[ventt]

Hi,

Yes, the link provided by @sstrell is right. The Stand-Alone Software can be found from FPGA Software Download Center (https://www.intel.com/content/www/us/en/collections/products/fpga/software/downloads.html?s=Newest)

Choose Quartus version > Downloads > Additional Software

Do you have further question regarding this?

Thanks.

[ventt]

Hi,

Since this thread been resolved, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, someone will be right with you.

If you happened to close this thread, you might receive a survey. If you think you would rank your support experience less than 10 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.

Thanks,

Best regards,

Ven Ting

p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 9/10 survey