- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi,
I've just received my development board, DE2-70, with TRDB D5M camera. First, in order to try the control panel software, I couldn't upload it to the Dev. board. Only got it working by removing the Modelsim software, and restart. Then, now, I'm going to test the DE2_70_CAMERA.exe application software that comes with the cd to test the camera. But, when I'm going to upload the code, after 100%, and after few seconds, it said " Execute (....NiosDownloadBatch.bat) fail, Exitcode: 1H." and 2nd warning, "Download Nios2 file (DE2_70_CAMERA.elf) fail! " I tried to burn the DE2_70_CAMERA to the fpga using quartus programmer, and after I open the DE2_70_CAMERA.exe application, it's connected. but no pic at all. If I click capture, it will pop up " Camera Capture Fail ". By the way, I've already tried copying the jtag_client.dll and dinkum_alt.dll to the 'SW" folder. And also have tried to change the environment path to point the bin at the quartus file. But still not working. Any Ideas?Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi.
i bought DE0 and camera module, but do not work, did you figure out anything? regards masoud
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page