FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5925 Discussions

The Ethernet ports of MAX 10 Development Kit suddenly stopped working.

Humusk
Novice
‎06-03-2019 01:51 PM
609 Views

The Ethernet ports of the boards no longer work. In the past I had a lot of problems to set up the ports as they were not working neither. After some time I discovered that I needed to press the reset button in order to link the port (when this happens a Green LED is turned ON on the port).

 

Now the ports are not working again, and the reset button doesn't work anymore as a workaround. Any ideas?

 

Thanks

Link Copied

1 Reply
Deshi_Intel
Moderator
‎06-07-2019 07:47 AM
330 Views
Hi, May I know did you face the issue with your own design or using Intel FPGA TSE IP reference design ? Can you try with below TSE reference design ? https://fpgacloud.intel.com/devstore/platform/16.0.0/Standard/max-10-single-port-triple-speed-ethernet-and-on-board-phy-chip-design-example/ This should help to isolate whether the issue is with the board, RJ45 connector, Ethernet cable or Quartus design issue. Thanks. Regards, dlim
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.