The question about arria10-netlength

[gongmh]

I downloaded this table from the official website, but there are two columns in it: Total Length (mm) and Total Delay (ps). Which data should I take as the criterion? What value should I set in the PIN DELAY of the PCB?

[Farabi]

Hello,

I am sorry, we dont see any table. Did you attached any files?

regards,

Farabi

[gongmh]

hello,

sorry ，I could not replyed on the basis of the previous one. The Intel Community team has resolved this issue.

now you can see the link :Re: Re:The question about arria10-netlength - Intel Community thanks a lot .

best wishes.