FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
4962 Discussions

USB BlasterII - Board side connector

NIzm
Novice
206 Views

Hello.

I am looking for the board side connector for USB Blaster II.
What is the model number of the recommended connector?

The connector of the box type such as the attached figure is hope.
The pin header may get a wrong direction, it is unnecessary.

Sincerely,

0 Kudos
1 Solution
ak6dn
Valued Contributor II
192 Views

There are literally dozens of manufacturers of parts like this. IDE box header 2x5, 100mil pin pitch.
There are both through hole and surface mount versions. All distributors carry them: Mouser, DigiKey, Allied, Newark, Arrow, ...

 

ak6dn_0-1606520418175.jpeg

Capture.JPG

View solution in original post

2 Replies
ak6dn
Valued Contributor II
193 Views

There are literally dozens of manufacturers of parts like this. IDE box header 2x5, 100mil pin pitch.
There are both through hole and surface mount versions. All distributors carry them: Mouser, DigiKey, Allied, Newark, Arrow, ...

 

ak6dn_0-1606520418175.jpeg

Capture.JPG

View solution in original post

NIzm
Novice
178 Views
Reply