FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5357 Discussions

USB BlasterII - Board side connector

NIzm
Novice
308 Views

Hello.

I am looking for the board side connector for USB Blaster II.
What is the model number of the recommended connector?

The connector of the box type such as the attached figure is hope.
The pin header may get a wrong direction, it is unnecessary.

Sincerely,

0 Kudos
1 Solution
ak6dn
Valued Contributor III
294 Views

There are literally dozens of manufacturers of parts like this. IDE box header 2x5, 100mil pin pitch.
There are both through hole and surface mount versions. All distributors carry them: Mouser, DigiKey, Allied, Newark, Arrow, ...

 

ak6dn_0-1606520418175.jpeg

Capture.JPG

View solution in original post

2 Replies
ak6dn
Valued Contributor III
295 Views

There are literally dozens of manufacturers of parts like this. IDE box header 2x5, 100mil pin pitch.
There are both through hole and surface mount versions. All distributors carry them: Mouser, DigiKey, Allied, Newark, Arrow, ...

 

ak6dn_0-1606520418175.jpeg

Capture.JPG

NIzm
Novice
280 Views
Reply