FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6189 Discussions

Unable to Program MAX7000S using Quartus II programmer

fhani2
Beginner
‎04-15-2020 06:04 AM
953 Views

hi Mates

it like i'm new to ALtera CPLD devices. currently working on MAX7000S family CPLD. when i connect EPM7128S through JTAG port using QUARTUS II programmer its detect the Chip with checksum 0x00000 but only BLANK CHECK option is available,  want to Erase and Configure it but none of Option is available. is there some license ,Software support issue, hardware issue or JTAG is disabled?

Please find attach picture for your reference

Preview file
111 KB
0 Kudos

Link Copied

1 Reply
sstrell
Honored Contributor III
‎04-15-2020 08:44 PM
875 Views

You have to specify a file to use for programming. Double-click <none> in the File column to choose the file and then enable the Program/Configure checkbox.

 

#iwork4intel

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.