Unable to run lpm_inv

[Altera_Forum]

Hello , 

I have the MAXII Micro kit with the EPM2210F324C3.  I have a small schematic project with a simple lpm_inv block. It compiles fine and downloads fine. But I'm unable to see any change on the output of the inverter when I change the input.  I'm extremely new to this and any help would be appreciated. My project is attached.

[Altera_Forum]

Your test waveform doesn't drive the inverter input. You actually don't change the input.

[Altera_Forum]

Thanks for replying, but how do you drive it. Is there an extra component that has to come beween the pin and lpm_inv? 

 For testing, I directly apply a signal to Pin C11.

[Altera_Forum]

I was referring to your simulation, that didn't drive the inverter. It works if setup correctly. If you have a problem with the real hardware, there's most likely a different problem, e.g. missing supply voltages. You can see from the compilation results, that the inverter should work.

[Altera_Forum]

Hi FvM, 

I created a vwf to simulate it, but the output does not wiggle with input(attached). The simulation is in functional mode and I generate the netlist before clicking start.  Thanks.

[Altera_Forum]

Could anyone have a look at my project and simulation. 

The simulation checks out, but I am unable to get it working on the dev. kit.  Thanks.