FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5915 Discussions

VCC pin connection of JTAG chain

VHou0
Beginner
‎06-22-2020 08:57 AM
644 Views

The red box in the figure below recommends that we connect the VCC of the download cable to 2.5V.

If we connect the VCC of the download cable to 3.3V and provide clamping diodes between the FPGA and JTAG as shown in the below , is it feasible?

cyclone10.PNG

Doenload cable.png

0 Kudos

Link Copied

2 Replies
VHou0
Beginner
‎06-22-2020 09:08 AM
640 Views

Hi Support team,

Our current connection is show below.

 

Doenload cable.png

 

Thanks in advance.

0 Kudos
Copy link
ShafiqY_Intel
Employee
‎08-24-2020 05:19 AM
609 Views
In response to VHou0

Hi VHou0,

 

We recommend to power up the VCC of the download cable with a 2.5-V supply from VCCA.

Other than this value, we are not recommend and you can try use other value on your own risk.

Thanks.

 

Regards,

Matt

In response to VHou0
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.