- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Anyone know why outputs that are not assigned in the programming of the kit end up displaying. For example ONLY pin ae23 LEDR0 is assigned to a counter output OP[3] but unassigned LED3 is blinking (different rate). Unused Pins was set to input tri-stated so that is not an issue. Sometimes 7-seg segments will light randomly - like just one of them. Once with a 50 MHz clock divider I had many LEDs lit that were not assigned. And there were others cases.
JackLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page