FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5203 Discussions

We are using arm angstrom linux system for the Cyclone V . What do we need to add in order to respose to a UDP Broadcast command?

MHar-
Beginner
250 Views
 
0 Kudos
2 Replies
Mike_Intel
Moderator
132 Views

Hello MHar,

 

Thank you for posting in Intel Ethernet Communities. 

 

Base on your inquiry, we have specific forum for these issues and I will be transferring this thread for faster response. 

 

Best regards,

Michael L.

Intel Customer Support Technicians

A Contingent Worker at Intel

Fawaz_J_Intel
Employee
132 Views

Hello,

Since you are running linux on board, you can use some linux commands to control the ethernet stream. I would start with tcpdump. If you cannot find tcpdump command, you might need to install it:

opkg install tcpdump

 

More information about this command can be found here:

https://www.tcpdump.org/manpages/tcpdump.1.html

 

 

Hope this might help.

 

 

Thank you

 

Reply