FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5918 Discussions

We have an Arria V GX starter board. I can not program the FPGA. How can I program the FPGA / make the JTAG-Chain work?

HEyer
Beginner
‎07-19-2019 11:36 AM
596 Views

After powering on the board, the green LEDS LOAD (D11) and D25 go on .

After about 4 seconds the red error LED (D11) goes on. 

 

When programming the USB-BlasterII is detected, but the device can not be programmed.

 

The JTAG Chain Debugger detects Device 1 , but there is a problem with the JTAG chain. See attached screenshot of the session log:

 

2019-07-19 13_32_43-JTAG Chain Debugger.png

 

What can I do to program the FPGA?

0 Kudos

Link Copied

1 Reply
AR_A_Intel
Employee
‎07-25-2019 03:14 AM
410 Views
Hello, Welcome to INTEL forum. This most probably looks like board prob. May I have the copy of invoice showing ship date and Development Kit Serial number? This is for further warranty checking. And you can also reply/attach your file in private message.
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.