FPGA, SoC, And CPLD Boards And Kits

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.

FPGA, SoC, And CPLD Boards And Kits

Discussions

CycloneIII 3c120 kit has very old factory configuration

DE0 NOIS II VGA Component

Cyclone III starter Kit control_panel issue

Cyclone III 3.3 volt tolerant?

request for reference schmatic and BOM for stratix4 GX device

pin assignment

Interfacing with Max V Development Board

Cyclone III starter kit software issues

Stratix-III DSP kit

Cyclone/Stratix USB interface problems

Using VIP Suite

Nios II System Architect Design Tutorial problem

wm8731 noise problem

PC <-> S530Dev. Bd. Reg R/W interface?

Cyclone III Starter Kit Input Pins

Featured Content

ID "166718"

NEW USB BLASTER II HARDWARE FAULT

EPM7128LC84-7N CANNOT BE ACCESSED

Re: EPM7128LC84-7N CANNOT BE ACCESSED

Re: TRI STATE BUS

Re: Issues Converting VHDL to Verilog for DE10 Standard Board