FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6181 Discussions

cyclone 10GX DDR3 (not DDR3L) fitter plan error "Error(20403): Global setting for OUTPUT_IO_TIMING_N

Yoram
Novice
1,728 Views

Cyclone 10GX EV board example design of DDR3x40 on Quartus pro 20.4

After IP upgrade (also without upgrade ). The following error occurs at the fitter plan stage:

"Error(20403): Global setting for OUTPUT_IO_TIMING_NEAR_END_VMEAS is not supported. Please use this setting with pin assignments."

On quartus 20.4 error message web page there is no reference to that number.

https://www.intel.com/content/www/us/en/programmable/quartushelp/20.4/index.htm#msgs/msgs/msgs.htm

On quartus 17.1 (origin of that core) there is no problem.

But cant use it because lacking of Ethernet stuff.

Please advice

0 Kudos
1 Solution
Yoram
Novice
1,663 Views

Not a big issue. But when I did upgrade the IP, some lines in the QSF file were marked as obsolete by quartus .

The unsupported setting of "OUTPUT_IO_TIMING_NEAR/FAR......."   was not commented as expected.

I did it manually as suggested in the first replay by sstrell.

View solution in original post

0 Kudos
7 Replies
sstrell
Honored Contributor III
1,690 Views

That sounds like a board trace model assignment.  Check your .qsf file and any board trace model assignments in the Pin Planner.

0 Kudos
Yoram
Novice
1,687 Views

done succefully.

Quartus 20.4 comment some irrelevant assignments when upgrade from previous IP versions but fail to comment the following:

"OUTPUT_IO_TIMING_NEAR/FAR......."

0 Kudos
AdzimZM_Intel
Employee
1,669 Views

Hi Yoram,


Do you still got the error message

"Error(20403): Global setting for OUTPUT_IO_TIMING_NEAR_END_VMEAS is not supported. Please use this setting with pin assignments." ?


What do you mean by your last feedback?

Quartus 20.4 comment some irrelevant assignments when upgrade from previous IP versions but fail to comment the following:

"OUTPUT_IO_TIMING_NEAR/FAR......."

Can you elaborated it?


Thanks,

Adzim


0 Kudos
Yoram
Novice
1,664 Views

Not a big issue. But when I did upgrade the IP, some lines in the QSF file were marked as obsolete by quartus .

The unsupported setting of "OUTPUT_IO_TIMING_NEAR/FAR......."   was not commented as expected.

I did it manually as suggested in the first replay by sstrell.

0 Kudos
AdzimZM_Intel
Employee
1,648 Views

Hi Yoram,


So now your problem has been fixed?


Thanks,

Adzim


0 Kudos
Yoram
Novice
1,629 Views

problem solved

0 Kudos
AdzimZM_Intel
Employee
1,603 Views

Hi Yoram,


Thanks to confirm about that.


I will close this case.


You can always file a new case in this forum if you got any problem.


Thanks.

Regards,

Adzim


0 Kudos
Reply