FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5157 Discussions

data transfer from fpga to hps

Altera_Forum
Honored Contributor II
826 Views

Dear all, 

 

i am using Altera SOC (Cyclone V) development board for my project. 

 

This board is receiving data on its GPIO (which is connected to FPGA side) at the rate of 27 MHz. It is continuous stream. 

 

I want this data to be available to ARM processor so that i will write c code to access this data and modify it and send it over ethernet.  

 

I am requesting help for how to access this data from c code? i have read that there are FPGA-to-HPS bridge through which data can be passed from FPGA to HPS. But in detail i am unable to figure it out this. Requesting for any design example or any links. 

 

Thank in advance
0 Kudos
3 Replies
Altera_Forum
Honored Contributor II
92 Views

Have you figured it out? 

I have the same question.
Altera_Forum
Honored Contributor II
92 Views

Can some one please reply to this post? I would like to know how to do this as well. We need this for our project.

Altera_Forum
Honored Contributor II
92 Views

 

--- Quote Start ---  

Can some one please reply to this post? I would like to know how to do this as well. We need this for our project. 

--- Quote End ---  

 

 

Has anyone made progress with this? I need to do it too. I only need to transfer four bytes at low speed. Chapter 5 of the Altera HPS documentation describes the three interfaces but now how to actually do it. Rocketboards.org have a couple reference designs that might help.
Reply