FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6188 Discussions

debugger problem using DS-5 and Byteblaster - cannot connect?

MCOUNSELL
New Contributor I
‎05-09-2019 03:45 PM
676 Views

Hi,

 

Does anyone have any ideas of the cause of this that I see quite often?

 

The target hardware identity could not be verified. Please check that the target being connected to is of type Cyclone V SoC (Dual Core) 

 

Debugging fails to start with this error dialog.

 

Mike

 

0 Kudos

Link Copied

1 Reply
Ahmed_H_Intel1
Employee
‎05-22-2019 03:54 PM
386 Views
Hi, If you are debugging across JTAG, please check the JTAG frequency. It is the most common issue. Regards,
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.