FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5016 Discussions

i am using arria 10 development kit. if i program the sof file through programmer i am getting jtag id error

AC1
Beginner
726 Views

i am using arria 10 development kit. if i program the sof file through programmer i am getting the error as

 

Error (209015): Can't configure device. Expected JTAG ID code 0x02E860DD for device 1, but found JTAG ID code 0x02E660DD.

Make sure the location of the target device on the circuit board matches the device's location in the device chain 

 can any tell what is the issue

0 Kudos
3 Replies
YuanLi_S_Intel
Employee
99 Views
Hi Anuradha C, May i know are you using the USB Blaster II to program the development kit? If it so, can you try to change the TCK frequency to 6MHz. You may refer to link below for the steps to change TCK frequency: https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/soluti... Thank You. Regards, YL
AC1
Beginner
99 Views

hello sir,

 

 

i am not using usb blaster 2 to program the device

sstrell
Honored Contributor III
99 Views

Also in the Programmer, make sure the tool is detecting the device correctly. Click Auto Detect and make sure to select the correct part number, if requested.

Reply