FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5930 Discussions

java.lang.Exception: No USB Blaster detected.

Altera_Forum
Honored Contributor II
‎06-18-2013 06:33 PM
2,114 Views

I am trying to use the Board-Test-System with a Cyclone V FPGA board and I keep getting this error. Another error I am getting that is possibly related is in the Programer software of Quartus II; I have the USB II driver installed but the program fails to load my program to the board. There is no error message that pops up, other than the fail status, however in <Hardware Setup___Add Hardware> it says "kernal mode driver not installed". I am running Quartus II v. 13.0 32-bit and Cyclone V Board-Test-System 12.0. 

 

Any suggestions on how to proceed?
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎06-19-2013 06:43 AM
638 Views

Hi, 

 

I had the same issue... 

 

You will need the corresponding Quartus Version from the BTS. 

In your case it is the Version 12.0.
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎06-19-2013 08:36 PM
638 Views

Thanks Taz1984, works now

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.