- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
dear sopc experts,
has anyone loaded the flash on altera cyclone III development kit? here my steps: 1. i generated a .pof-file from my .sof-file 2. i loaded the .pof-file into the flash S29GL512N with options 0x0038'0000, start address 0x0000'0000 3. then set the pgm config select rotary swith on position 1 4. then set max0 at dip-switch sw1 on closed (like all others at this dip-switch) 5. power off, power on 6. result: error led is on (the red led), fpga is not configured.... can anybody tell me, what i've done wrong? thanks in advance! retoLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page