FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5930 Discussions

load program from EEPROM to FPGA cyclone II

Altera_Forum
Honored Contributor II
‎05-09-2015 02:40 PM
1,541 Views

I work on an Altera DE1 board and I use Quartus II 9.1 web edition, when I load my program with active serial programming using EPSC4 device ,my program loads in the EEPROM and I can not seem to get it back into the FPGA 

my question is how can I configure my card to read the program from the EEPROM 

 

 

thanks in advance
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎05-22-2015 03:10 AM
400 Views

Hi there, 

 

I'm not sure if I understand your question correctly. I assume that you have no problem programming the EPCS4 device and it is programmed successfully.  

 

However, the FPGA doesn't seem to be programmed from the EPCS4 device upon power up. Is that what you are asking ? 

 

David from Terasic
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎06-02-2015 02:05 PM
400 Views

Make sure the configuration scheme is set to Active Serial mode under the configuration scheme in the Quartus II "Device and Pins option" settings. If you set to other configuration scheme such as Passive Serial then the configuration would fail.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.