- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just got my Cyclone III Starter Board and am learning my way around Quartus II and the device, very cool stuff so far :)
Having just completed the "my first fpga" tutorial I have a question, where I can get the "definitive" pinout for the development board!! The tutorial says one thing, the example project from altera uses another, and the reference manual says another. The tutorial says Button[0] = V0 LED[3] = N0 Osc_Clk = F1 The Altera Example Project uses Button[0] = F1 LED[3] = N0 Osc_Clk = V9 The Reference Manual says Osc_Clk = B9 in one table and V9 in another (am I miss reading?) Leaving me VERY confused :(Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The only good documentation is the board schematics, unfortunately.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page