FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
All support for Intel NUC 7 - 13 systems has transitioned to ASUS. Read latest update.
5850 Discussions

programmer error with Intel S10mx development kit

clair
Novice
713 Views

Hi,

    I tried to program .sof file into Intel S10mx development kit,but failed.

I reboot the PC several times and I try different PC, the errors came up the same .

 

Error(18952): Error status: Synchronization failed

Error(20068): Configuration error, you must power-cycle the device to recover from this condition. To avoid this error you must ensure that the device is configured within 18 seconds after completion of the power-on sequence.

Error(209012): Operation failed

捕获.PNG

 

0 Kudos
5 Replies
JohnT_Intel
Employee
697 Views
0 Kudos
clair
Novice
685 Views

Hi, John

   I did program the fpga after power up.

   The link you mentioned above provide the solution for S10 SX/GX, not for S10mx. And I have tried the  Patch 0.13 Link, and it didn't work.

  Thanks.

Best regards

0 Kudos
JohnT_Intel
Employee
671 Views

Hi,


If you look into the KDB, it mention it is happening on ES1 device of Stratix 10 MX device. May I know if you are still seeing the same issue if you immediately program the FPGA after power up?


Impacted Stratix 10 MX variants

  • Intel Stratix 10 MX 2100 H-Tile ES1



0 Kudos
clair
Novice
641 Views

Hi,JohnT

     I said I have tried the solution, but it did not work. 

     Now I can solve the problem by power off the mainboard and restart. However I've been trying to type “reboot” to restart the computer which often failed.

0 Kudos
JohnT_Intel
Employee
621 Views

Hi,


May I know when you performed reboot, is the board configured? The reason is that reboot will not power cycle the FPGA>


0 Kudos
Reply