- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear All,
Anyone can help me? After I install the USB blaster driver, My Cyclone III FPGA Starter Kit worked at the first time, but can not be detected afterwards after I disconnceted the power and connect the power again. It says ""Fail to Connect your development board" using the starter kit controal panel. I re-install the driver again and again , still failed, I also used Windows device manager to delete the USB Blaster, and reinstall again, still does't work anymore. What should I do? It is Winodows 7, a notebook. Thank you very much!Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Was it due to I erase the flash memory last time?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page