FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5234 Discussions

"Fail to Connect your development board"-Cyclone III Starter Kit

Altera_Forum
Honored Contributor II
848 Views

Dear All, 

 

Anyone can help me? 

 

After I install the USB blaster driver, My Cyclone III FPGA Starter Kit worked at the first time, but can not be detected afterwards after I disconnceted the power and connect the power again. 

 

It says ""Fail to Connect your development board" using the starter kit controal panel. 

 

I re-install the driver again and again , still failed, I also used Windows device manager to delete the USB Blaster, and reinstall again, still does't work anymore. 

 

What should I do? It is Winodows 7, a notebook. 

 

Thank you very much!
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
114 Views

Was it due to I erase the flash memory last time?

Reply