- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using DE1 board and QuartusII 9.1 SP2 & Software Build Tools for Eclipse.
I set the reset address to flash in sopc builder and set the .text to sdram in SBT. I use the SBT's flash programmer to download the *.elf file to flash and download the *.sof file the EPCS4, and the programmer's message shows the download is successful. But when I reset the DE1 board , the leds are not on . why ?Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
And I have tried to download the *.pof file to EPCS, the result is the same__no leds on.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page