tse_ip jumbo packet configuration

[ysfkrbt_06]

Hello,

 I am using tse_ip to obtain  jumbo packet . My  core variation  10/100/1000Mb Ethernet MAC with 1000BASE-X/SGMII PCS. Also I chose  MAC option as below

Enable supplemental MAC unicast addresses 

Enable full duplex flow control

and my fifo size 16384 x 32 bits .

Also I set  mac configuration  such as frm_length = 9600   TX_SECTION_EMPTY register and TX_SECTION_EMPTY register  properly .

But my design does not send 8028 bytes (IP HEDER + UDP HEADER + PAYLOAD) .

If  I try to send 2000bytes paylod with same setting , I observe UDP package on wireshark .

Could you help me how can I send 8000 payload with this IP? 

[paveetirrasrie_Intel]

Hello,

Here's the way on how to work with Jumbo frames.

https://www.intel.com/content/www/us/en/docs/programmable/741328/24-3/using-jumbo-frames.html

Kindly let me know if that helps

Regards,

Pavee

[ysfkrbt_06 · Accepted solution]

Hello,

I applied this methodology( https://www.intel.com/content/www/us/en/docs/programmable/741328/24-3/using-jumbo-frames.html ) but you don't need these file changes.

Actually, I solved my problem. My mistake was that I didn't realize that  tse_ip  is fed with 4-byte data and I mistakenly tried to send 8000* 4 byte. As I mentioned before I could send 2000 cycles, which means I actually sent 8000 bytes

Regards,

ysfkrbt_06