- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I noticed in the demo for the DE2 Altera board that the GPIO_1 connections does not match the specifications given by the user manual. for example, I noticed that GPIO_1[16] was used for the CCD_MCLK and not GPIO![18] which is the pin connected to the XCLKIN pin of the camera module. However the case, when I changed the pin in the demo code, the result went wrong (looking into the lcd touch LTM). the correct pin is still [16]. I don't understand why this is so.Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page