Reference Design: Gen3x8 AVMM DMA - Stratix 10

Suchergebnisse werden angezeigt für 
Stattdessen suchen nach 
Meintest du: 

Reference Design: Gen3x8 AVMM DMA - Stratix 10

Reference Design: Gen3x8 AVMM DMA - Stratix 10

The purpose of this page is to provide a link to the user, where the user can download the Stratix 10 PCIe Gen3x8 AVMM DMA reference design. For the DMA details, refer to the user guide below.



  • Fast and easy to develop high performance PCIe Gen3x8 hardware
  • Example system is in the attached Quartus archive, which provides a pre-configured Qsys system
  • Includes 64-bit Windows and Linux driver and application that works with the example design
  • Example design throughput averaged across 8 kBytes transfer with descriptors overhead
  • Read/Write : up to *6.4GB/sec* per direction
  • Simultaneous read/write : *11.5GB/sec*


  • ACDS 17.0 IR3, Stratix 10 L-Tile Device
  • Example Design

Altera PCI Express Stratix 10 Development kit with 1SG280LU3F50E3VGS1

A system with either 32-bit or 64-bit Linux or 64-bit Windows 7 installed

How to run the application

Follow the following instructions to install and run the application

  1. Copy the attached Linux application and driver into a folder
  2. Unzip the application and driver
  3. Open a Terminal in Linux and go to the folder where the application is copied and unzipped
  4. Log in as an Admin by type in "su" and enter the password
  5. Type in "make" to compile the driver and application. Just need to do it once in a system.
  6. Type in "./install" to install the driver
  7. Type in "./run" to run the application

In the application, there are multiple options to configure the software. The user can run read DMA (move data from system memory to the on-chip memory in the FPGA), write DMA (move data from on-chip memory to system memory), or simultaneous read and write. The user can also control the transfer size of each descriptor, the number of descriptors, and how many loops the DMA runs. There is a description to explain all the options when the application is started. To run the DMA, type in "1" to start it.


Hardware Download

Revision 1

The reference design was created in ACDS 17.0 IR3

Link to download the project Ep g3x8 avmmdma256 integrated


Software Download


Revision 1

Link to download the application and driver Linux for AVMM DMA On Chip Mem.tar.gz



Revision 1

64-bit Windows driver and application:Gui package 090

In the package, there is a word document that explains how to install the driver, what additional software needed to be installed, and how to run the application.



April 14, 2017 - Created this page

Letzte Aktualisierung:
‎09-28-2020 03:05 PM
Aktualisiert von: