- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am trying to configure the DMA controller dedicated to the UART in the Intel Quark x1000 SoC.
I am not able to set the "Channel Enable" CH_EN_REG.CH_EN bit to 1.
Do you have a documentation that explains the operation of the DMA controller and how to configure it ?
Thanks.
1 Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I found the answer in the Datasheet of ATMEL (Microship today).
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Thank you for reaching out to Intel® Quark™ Microcontrollers Forum.
We will look into this issue and get back to you shortly.
Regards
Intel Customer Support
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page