- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
I want to Connecting the Pixhawk Flight Controller to the Intel® Aero Compute Board, so I according to the official documents.
but i found I have not the /etc/init.d/mavlink_bridge.sh , but i have mavlink-routerd.sh in the same folder.
i connect my pixhawk with Aero,and nothing happen.
I don't not what?How to do?I want to use my aero quickly.
ps:
my aero version:
sh-4.3# get_aero_version.py
OS_VERSION = v01.00.04
AIRMAP_VERSION = 1.8
FPGA_VERSION = 0xff 0xff
1 Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi Tallent_you,
According to https://github.com/intel-aero/meta-intel-aero/wiki/Software-Release-Notes Mavlink Bridge was replaced with Mavlink Router, so try to follow the http://www.intel.com/content/dam/support/us/en/documents/boardsandkits/aero/apu-161110-pixhawk-fligh... official guide disabling mavlink-routerd.sh.
And about your recommendation, we really appreciate it, and I just want to let you know that we are working on updating the document.
Let us know if you still have issues.
Have a nice day.
Regards,
Leonardo R.
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi Tallent_you,
Thanks for reaching out.
That's a good question. We are going to test it, and we will contact you when we have updates.
Have a nice weekend.
Regards,
Leonardo R.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi Leonardo,
Thank you for your reply.
And I recommend the official offer a more specific guide (about Connect and Using the Pixhawk Flight Controller to the Intel® Aero Compute Board).
Tallent
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi Tallent_you,
According to https://github.com/intel-aero/meta-intel-aero/wiki/Software-Release-Notes Mavlink Bridge was replaced with Mavlink Router, so try to follow the http://www.intel.com/content/dam/support/us/en/documents/boardsandkits/aero/apu-161110-pixhawk-fligh... official guide disabling mavlink-routerd.sh.
And about your recommendation, we really appreciate it, and I just want to let you know that we are working on updating the document.
Let us know if you still have issues.
Have a nice day.
Regards,
Leonardo R.

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page