Intel® Collaboration Suite for WebRTC
Community support and discussions on the Intel® Collaboration Suite for WebRTC (Intel® CS for WebRTC).

In MCU mode in 2 node cluster the output video stream switches the location of the inputs

Mark_d_10
Beginner
367 Views

Hello,

I've been testing with my cluster setup again, in MCU mode, I have 2 connected input streams from different 2 sources.
In the mixed output stream then the inputs switch of location in the layout randomly.

It is also visible in the recording, but that is because it's the same output stream I guess?

Any ideas on how to fix this?

If needed I can share by mail a short video demonstrating the problem

0 Kudos
3 Replies
Lei_Z_Intel1
Employee
367 Views

Hi, Mark

Have you enabled the VAD (Voice Activity Detection) during the room creation? This feature may trigger the input with most active audio occupy the first region of the layout.

Best wishes,

Zhai Lei

0 Kudos
Mark_d_10
Beginner
367 Views

Hi Zhai,

Thank you, that was it, however this setting is called "avCoordinated" in de management console. So it was a bit of a search.

 

0 Kudos
Lei_Z_Intel1
Employee
367 Views

That's good. Enjoy!

0 Kudos
Reply