Intel® Enpirion® Power Solutions
Interact with Intel® product support specialists on Intel® Enpirion® DC-DC Step-Down Power Converters
Announcements
This forum offers only peer-to-peer support. Thank you!
225 Discussions

Hello, I'm working on the ARRIA 10 powering and I'm trying to find out what power supplies are constantly required for the fpga to work properly. could someone help me? Thank you

AREIL3
Beginner
1,427 Views
 
0 Kudos
3 Replies
Rahul_S_Intel1
Employee
682 Views
Hi , I recommend you to refer the power down and power up sequence in Arria 10 . And design the board with the recommendation given below in the document. https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an692.pdf Regards, RS
AREIL3
Beginner
682 Views

Hi,

Thank you for your answer.

What I'm trying to find out is: what happens with the FPGA if I lose the power supply of VCCERAM  during the use of the FPGA, for example !?

 

Regards,

Amaury

 

0 Kudos
Rahul_S_Intel1
Employee
682 Views
Hi , Please check the page no 325 of the below document , in that VCCERAM is monitored by POR so the power cannot be taken out https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/arria-10/a10_handbook.pdf
0 Kudos
Reply